Investigating the Effect of Resistance on a Capacitor Circuit :: Papers

Investigating the Effect of Resistance on a Capacitor Circuit Method: We will set up the following circuit. We will measure the capacitor pd. (Vc) with the cell connected. Then we will remove the cell and connect point A to point B, at the same moment starting a stopwatch. We will record the length of time (t) for the Vc to decay to 3.75 Volts. We intend to repeat this procedure using different resistors. [IMAGE] Resistance (kW) Time (s) 33 33 68 72 100 97 150 153 330 320 680 584 Conclusion: From the graph we can clearly see that the time taken for the capacitor to discharge is directly proportional to the resistance. This is because the graph shows a definite straight line going through or near most of the points. This means that the higher resistor you use the longer it will take for the capacitor to discharge. The experiment has therefore proved the prediction correct i.e. the resistance should be directly proportionate to the time taken for the capacitor to de-charge. This can be explained by the following: Capacitors store electrical charge. When current is passing through the circuit the capacitor charges up as the current can't jump between the gap of the two plates but charge is held there because of the force of the opposite poles. This means that more and more electricity is stored until it reaches its full capacity. But when the circuit is broken the capacitor de-charges releasing electricity through the circuit. The resistor slows down the current causing 'congestion' and means that the capacitor has to de-charge slower because only a limited amount of charge can travel through a circuit with a high resistance at any one given time. Evaluation: The method was a good way of carrying out the experiment as it was quite easy to conduct once the circuit was connected, the results seem